Page 1 of 1

samsung 248f

PostPosted: Thu Mar 27, 2003 3:20 pm
by grifter
hi, i just got a new samsung 248f last night and hopefully someone can help me out. after i installed the drive, i put in a music cd to test it out. it worked beautifully. then, i tried burning a cd at 48x speed. it was going good until the end parts of the burn when the actual burn speed went down to 1x and it seemed like the session had frozen. i was about to cancel the session when it started again. it finished and a log popped up to show me what the errors were. i saw on another forum for asus a7n8x nforce2 boards (which is what i have) that i should try installing a aspi layer from the adaptec website. now, my cdrw drive doesnt read any type of cd, whether it's a cd-r, music cd, etc. did i mess up the laser when i tried burning at 48x speed or is there some other problem. thx for your help in advance.

PostPosted: Thu Mar 27, 2003 5:11 pm
by grifter
i upgraded to the newest firmware, but that didn't help. i think it might be the laser because the disc is spinning and all i hear is a noise that sounds like it's trying to read the disc, but can't. it keeps making the same noise every 5 seconds then i guess it determines that there is no disc in the drive.

PostPosted: Fri Mar 28, 2003 5:32 am
by grifter
anyone have any ideas?

HI

PostPosted: Sat Mar 29, 2003 4:02 pm
by music_lover
WELL I WOULD SUGGEST CLEANING OF THE LENS BUT AS IT IS A NEW ONE I DONT THINK THIS MIGHT WORK I FEEL U WOULD RATHER PUT UR WARRANTY IN ACTION OR RATHER EXCHANE IT WITH UR VENDOR

PostPosted: Tue Apr 01, 2003 4:45 pm
by guarana2.5
Check all the cables or try try the drive on a different ide channel.
I have a 248f too, it works great but it can be quirky.