Page 1 of 1

kprobe no longer working

PostPosted: Sun Dec 14, 2003 9:36 pm
by maninacape
When doing the C1/C2 PIPO scan, immediately after "set CD Speed" comes up in the status bar it says "Done" and the test finishes without giving me any results (empty graph, no avg errors, nothing). The last time I used krpobe was last week and it worked fine.

The only thing that's changed (that I can think of) is that I installled CDex and Nero's ASPI drivers, which CDex needed. Could this be the problem? If so, where can I find a suitable set of drivers?

Edit: Installed adaptec's ASPI drivers and everything is ok.

PostPosted: Sun Dec 14, 2003 10:06 pm
by CDRecorder
Welcome to CDRLabs! :D

I'm glad that you've already figured out the solution to your problem! :)