Page 1 of 1

problem with WinOnCD 6

PostPosted: Thu Jun 05, 2003 4:52 pm
by erhan
I have got Lite-on 52x24x52 cdwritter. I installed winoncd 6. whenever I try to burn empty cd I am getting this messages which are below

There is not enough free space on the Disc.

Disc Information Summary:
Disc Type: CD
The free space on this medium is 0 Bytes (in data mode) (00:00:00)
The recordable space starts at position 00:02:00
The last block usable for recording is at 00:01:74
Information about the requirements of the current project:
The current project has 1 track(s), requiring 656 KB (00:04:28) of free space.


Additional Information:
UPC/EAN code is not present
even i erase the cd again and again i am still receiving this
what should i do?
Thank you ver much
erhan
Turkey

PostPosted: Thu Jun 05, 2003 8:38 pm
by Inertia
CD-R discs can't be erased. This can be done only with CD-RW discs.

The message you are getting shows no free space on the disc, which is an indication that it has already been written and closed. If this is so and it is a CD-R disc, it is no longer writable.

Try a new, unused CD-R disc and report the results.

PostPosted: Fri Jun 06, 2003 10:51 am
by Han
Looks like you're trying to write on pressed (non-recordable) disc...

WinOnCD 6 should report the following info about blank CD-R:

This disc can be used for recording.

Disc Information Summary:
Disc Type: CD-R
The free space on this medium is 702 MB (in data mode) (79:57:73)
The recordable space starts at position 00:02:00
The last block usable for recording is at 79:59:72


Apply the latest Service Pack and uniDRV.

PostPosted: Wed Jul 23, 2003 9:29 am
by mikey4
Check if WinOnCD is using the right drive and the right driver for it. It looks to me like you need to configure something manually.