Page 1 of 1
killed my mother board?
Posted:
Tue Mar 11, 2003 3:39 amby kaga
ok i got my AMD XP 2200 when i try to install it i had a hard time puting the heat sink in and my screw driver hit some part of the mobo. now i have problems with the boot when i turn on the computer i get no video signal and when i try to turn off the power i can't have to do it from the power supply. did i killed it ?
Posted:
Tue Mar 11, 2003 3:51 amby BuddhaTB
I would check all of your cable connectors and jumpers on the motherboard before jumping to the conclusion that your motherboard might be dead. Make sure they are set correctly and the connections are tight. Also check to make sure the video card is all the way into the agp slot if you don't have onboard video.
What's the make and model of your motherboard?
Posted:
Tue Mar 11, 2003 8:34 amby aviationwiz
GA-7VRXP
Look in his sig.
Posted:
Tue Mar 11, 2003 2:11 pmby dimitri
Did you kill your mobo? Sounds like you injured it. If it was dead you wouldn't get it to run at all.
It's a very common mishap. You should look for the acrewdriver scratch and examine it with a magnifying glas. If you see any shiny metal color in it, you've damaged a lead. It usually can be repaired by professionals. Ask your vendor.
Posted:
Tue Mar 11, 2003 6:20 pmby CignaXI
I have your same problem with my mobo, I recently purchased a XP 2100+, I sent it back to replace it and they sent me a model 8 (0.13 microns) version. My ECS K7VTA3 v2.x supports model 6 (0.15 microns) but the model 8 not. I don't get video signal and my keyboard's num lock key doesn't work. You should go to amd's site and check if your mobo supports your cpu:
http://www.amd.com/us-en/Processors/Pro ... 8_756_3734^4348^7923,00.html
You should also check your power supply, sometimes the psu doesn't provides enough mA to support the CPU.
PS: copy/paste the link don't click it.
Posted:
Tue Mar 11, 2003 8:13 pmby kaga
but then i swap back my Tbird 1.1Ghz and still the same thing
Posted:
Tue Mar 11, 2003 8:16 pmby kaga
i think i probal scrath it any one know where can i get it fix?
Posted:
Wed Mar 12, 2003 1:56 pmby dimitri
kaga wrote:i think i probal scrath it any one know where can i get it fix?
I think you better say where you are mate, I suspect an address in Lapland might not suite you
Usually the place you bought it can arrange it for you, or at least give you the address.
Posted:
Wed Mar 12, 2003 2:49 pmby CignaXI
Good Luck Kaga!