Page 1 of 1

CDRWIN 4.0 won't recognize Verbatim CDRW DRive (Cendyne?)

PostPosted: Thu Feb 27, 2003 9:37 pm
by mpg85
I am trying to burn bin/cue files using CDRWIN, but when I install it, it will recognize the CDRW driver as the "Reading" drive, but will not recognize the CDRW driver as the "Recording " drive. I also seem to have a clash with "Nero Express" when I install CDRWin.

Have looked for updates of drivers but had no luck.

The drive in question is a Verbatim 48X12X48 CDRW (It's also listed as a Cendyne? at Office Max). Purchased about 4 months ago.

Any suggestions?

Thanks

PostPosted: Thu Feb 27, 2003 10:07 pm
by Bloody Aztec
CDRWIN 4.0 is a kinda old version, get the latest 3.9C that's what you need.

PostPosted: Fri Feb 28, 2003 6:46 am
by Joker
It sounds strange, with the smaller number being the latest version, but version 4 was given up on, and they went back to version 3 updates. The current version is 3.9C dated 02-15-2003. If you have trouble with it, go to 3.9C dated 02-04-2003. In my case, with a Lite-On 52246S, if I use the 3.9C dated 02-08-2003 or the version dated 02-15-2003, the program will crash reading a cuesheet if the write speed is set above 40X (52X or MAX setting). It also crashes if you read the cuesheet at a lower speed, and then select 52X or MAX. So if that happens to you, go back to the 3.9C dated 02-08-2003 as that version works fine at higher than 40X.

Joker