Page 1 of 1

Master and slave settings

PostPosted: Thu Jan 20, 2005 11:16 am
by griz
Hi,

I've got one HDD, a Lite-On DVD burner and a Samsung combo drive. Is there an ideal configuration as far as IDE channels and master / slave settings?

Thanks for the insight!

PostPosted: Thu Jan 20, 2005 11:51 am
by jberry
you have 2 IDE channels...your harddrive is already on 1 of them (the primary one). Your burners are on the secondary one (they should be). You can have 2 devices per channel for a total of 4

you can use cable select if you want and you cable supports it. Or make the burner master and combo drive slave. Since your hardrive is on the primary IDE channel your burner and combo settings will not affect it.

good resource for this is:

http://www.pcguide.com/ref/hdd/if/ide/conf_Channels.htm

PostPosted: Thu Jan 20, 2005 2:46 pm
by hoxlund
please for the love of god don't use cable select, your smarter then that

PostPosted: Thu Jan 20, 2005 3:35 pm
by jberry
yah yah i know.....just given all options

PostPosted: Thu Jan 20, 2005 7:02 pm
by burninfool
hoxlund wrote:please for the love of god don't use cable select, your smarter then that


I've used CS for a couple of years with no problems...maybe I'm not that smart. :wink:

PostPosted: Sat Jan 22, 2005 7:16 am
by ETP
I don't use CS anymore but I think it works fine if both drives are set to CS and your BIOS is set appropriately.