Page 1 of 1
how to use artec dvd r/wr drive?
Posted:
Mon Jan 31, 2005 11:57 pmby unknown
I have quick question, I have a artec dvd burner, but for some odd reason it does not work, my computer recognizes that its connected, but it does not read any type of disk, my computer also tells me that the drive is not ready, even though my computer states (that the device is working properly), nero is installed on my computer, but it doesn't help anything, how do fix this problem?
Posted:
Tue Feb 01, 2005 2:00 amby hoxlund
what system specs do you have?
also check the jumper settings on the back of the drive
reply
Posted:
Tue Feb 01, 2005 2:25 amby unknown
AMD ATHLON XP 2000+
1 GB OF MEM.
ARTEC DVD ROM DRIVE
ARTEC DVD R/WR DRIVE
ETC...
does it have to be set to master or slave?
Re: reply
Posted:
Tue Feb 01, 2005 3:17 amby Wesociety
unknown wrote:AMD ATHLON XP 2000+
1 GB OF MEM.
ARTEC DVD ROM DRIVE
ARTEC DVD R/WR DRIVE
ETC...
does it have to be set to master or slave?
It depends where you installed it.
End of the cable = master.
Middle of the cable = slave (with another device connected to the end as master).
Re: reply
Posted:
Tue Feb 01, 2005 3:32 amby unknown
Wesociety wrote:unknown wrote:AMD ATHLON XP 2000+
1 GB OF MEM.
ARTEC DVD ROM DRIVE
ARTEC DVD R/WR DRIVE
ETC...
does it have to be set to master or slave?
It depends where you installed it.
End of the cable = master.
Middle of the cable = slave (with another device connected to the end as master).
Its in the middle with the dvd rom drive as master and dvd r set at slave.
Posted:
Tue Feb 01, 2005 1:43 pmby hoxlund
what model is the dvd burner? first off when you buy a optical drive
first thing i would do is update the firmware, then double check the bios to make sure its going into DMA mode and also check in windows for DMA mode
reply
Posted:
Tue Feb 01, 2005 9:13 pmby unknown
artec dvd r/wr, 12x, vom-12e48x 100a
I thought so, I just downloaded an undate firmware and boot disk tool.