Page 1 of 1

could not perform end of disc at once error

PostPosted: Sat Feb 19, 2005 11:50 am
by davros
hello forum, my pioneer 108 works brilliant when writing dvd's but when trying to write to cdr's I always get the above error message. It gets to the end of the disc then the buffer empties and I get the burn failed message. I have used nero (latest updates) and record now max both do the same????
I have aspi installed dma is switched on and it does it with ritek 52x discs and memorex and also cmc. As I said earlier dvd's record flawlessly.....any ideas anyone?????????

PostPosted: Sat Feb 19, 2005 1:00 pm
by dodecahedron
hello again davros (Exterminate!!! Exterminate!!! :D )

did you try using quality media?
if possible, Taiyo Yuden CDRs.

sounds a bit like the drive is faulty :(

probably not a software issue, but why not try burnatonce too?
www.burnatonce.com (freeware)

lol@exterminate!

PostPosted: Sun Feb 20, 2005 7:11 am
by davros
hello again....I think I have solved it....I took off all my burning programs and just re installed nero 6 and record now max and both seem to be behaving normally.....fingers crossed it doesn't start ruining discs again

PostPosted: Sun Feb 20, 2005 7:39 am
by dodecahedron
good luck