Page 1 of 1
Best Firmware for the BenQ DW1640?
Posted:
Thu Jul 27, 2006 6:05 pm
by stix
what's the best firmware for the 1640? Why?
thanks for any input on this.
Posted:
Fri Jul 28, 2006 12:43 am
by Bhairav
BSLB. No question, the later firmwares were probably coded by Lite-On engineers, 1213S/1633S vintage!
Good write quality, basically.
Posted:
Fri Jul 28, 2006 10:33 am
by burninfool
I like BSOB,I tried the newer ones and went back because of write and read issues.If you want to use QSuite 2.1 you must use BSMB or newer:
http://club.cdfreaks.com/showthread.php?t=154259
Posted:
Fri Jul 28, 2006 11:05 am
by Ian
QSuite will work with older firmwares. It just doesn't let you view the supported media.
Posted:
Tue Nov 21, 2006 4:41 pm
by hrbngr
My favorite f/w is also BSLB.
I only burn MCC 004 (@12x) and Yuden T02 (@8x).
Almost always 97%+ quality, somedays even better than that.
Posted:
Wed Nov 22, 2006 8:12 am
by SkaarjMaster
Speaking of QSuite, is there any reason to install the BenQ software at all?
Posted:
Wed Nov 22, 2006 2:13 pm
by hrbngr
I would absolutely install QSuite, so you can verify if the dvd+r is set to dvd-rom and what settings your drive is running. otherwise i generally run imgburn and dvdshrink for everything else.
Posted:
Wed Nov 22, 2006 9:54 pm
by SkaarjMaster
Doesn't Imgburn already show this before burning (or at least it can be checked and changed if necessary)? Also, Nero InfoTool does all this as well I think.
Posted:
Fri Nov 24, 2006 10:47 am
by dodecahedron
i don't think InfoTool shows this. but Nero CDSpeed does.
QSuite has a FE/TE test to check the media quality. but i don't know much about it.
Posted:
Fri Nov 24, 2006 12:13 pm
by SkaarjMaster
As long as it doesn't conflict with any other software I have installed, I might go ahead and install it and check it out. Thanks.
Posted:
Tue Nov 28, 2006 12:24 am
by TCAS
I also vote for BSLB it is the best one for BenQ drive 1640 so far according to my own experiece.
Posted:
Thu Dec 07, 2006 10:10 pm
by KG
My 1640 came with BSMB, do official BenQ firmwares allow downgrade so I can flash BSLB on it?.
Posted:
Thu Dec 07, 2006 11:36 pm
by burninfool
KG wrote:My 1640 came with BSMB, do official BenQ firmwares allow downgrade so I can flash BSLB on it?.
Yes,flash away.I tried them all and went back to BSLB,DVD write quality was one problem and the newer ones have problems with audio CD's.